Woodoc 20

Woodoc 20

 16,50 29,95

add to wishlist
add to wishlist

Description

Woodoc 20 is a special way of finishing, it is not oil but it is also certainly not lacquer! It is a mix of polyurethane and wax. Woodoc 20 gives a glossy finish. It penetrates like an oil and it protects like a lacquer.

  • It gives a wood a look as if it is oiled.
  • Easy to apply
  • Penetrates deep into the wood. Nourishes the wood and accentuates the grain.
  • Water & Alcohol Resistant
  • Heat and cold resistant
  • Scratch resistant
  • Not harmful after drying.

Tips on applying Woodoc 20

  • Woodoc 20 contains various fabrics that sink down into the jar. Therefore, shake the pot well before use and stir in the pot for prolonged use. If Woodoc is shaken it should be a bit amber, it looks like tea with milk.
  • Apply it in three layers for optimum protection.
  • The first layer is the most important. This layer must penetrate deep into the wood and is the foundation for the next layers. During application, dull spots will soon occur. Immediately update it by adding extra Woodoc. Continue until a glossy layer is used for 10 minutes.
  • Allow the first layer to dry for 8 to 12 hours (depending on the conditions) following layers dry in 1 to 3 hours.
  • Always light sanding between different layers. This ensures that the fibers that are pressed out of the wood because the wood gets saturated again are sanded away and a tight surface arises for the next layer.
    • Remove abrasive dust and wipe the surface clean with turpentine or white spirit. Do not use water.
    • Before putting the first layer to grit 180. Between Layer 1 and 2 use grain 240.
    • Grain 320 between Layer 2 and 3.
    • After the third layer you do nothing more. Super smooth Glossy finish.

Other tips:

Use Woodoc 20 not on the floor, use Woodoc 25 or Woodoc 25w use Woodoc 20 only on indoor products. If you want to treat previously lacquered wood with Woodoc 20 remove all old coatings and start again with Kaalgeschuurd Wood. If you want to treat previously oiled wood with Woodoc 20 then remove the oil by sanding the surface well and clean it with white spirit or turpentine. Remove any residues with a sch0ne dry cloth and allow the surface to dry properly. If you want to deal with Wooddoc 20 treated wood again, sand the surface then lightly with BV wool 0000 and re-apply the Woodoc. With 1 liter Woodoc you can handle about 3.3 m² (3 layers). Woodoc 20 is available in 0.5 litres, 1 litre and on request per 5 litres. Woodoc compared to other finishers download here as PDF (English).    

Additional information

volume

0.5 liter, 1 liter

SHARE

Select a Pickup Point